ZAPCO AMPLIFIER 9.0 Start Price USD 900.00 Current Price USD 900.00 Time Left - Bid Count 0 Buy It Now Price - Reserve Price - Start Time Saturday, September 06, 2008 End Time Tuesday, September 09, 2008 Location everett, WA See more about 'ZAPCO AMPLIFIER 9.0' Description Stereo, 4 ohms: Stereo, 2 ohms: Stereo, 1 ohm: Bridged, 4 ohms: Bridged, 2 ohms: T.H.D. + Noise: Frequency Response: S/N Ratio: Transient Distortion: Slew Rate: Damping Factor: Input Sensitivity: Dimensions: 2 x 300 Watts 2 x 600 Watts 2 x 1100 Watts 1 x 2200 Watts 1 x 2200 Watts <0.05% @ 4 ohms 20Hz - 20KHz, + 0dB / -0.28dB >85dB <0.009% >20V/uS >225 @ 4 ohms 250mV - 16 Volts 19.5"L x 8.75"W x 2.375"H                                 SPECIFICATIONS     FEATURES 2-Channel High Efficient Full Range Class D Amplifier with Tripath Microprocessor Control Technology Over 2000 Watt RMS Power into 2 Ohm or 4 Ohm Configuration -Chassis design allows infinite customization options by replacing slide-in trim panels to personalize any installation- SymbiLink™ Balanced Line Technology provides up to 16 volts of balanced input for the cleanest, quietest signal possible -Dual 1,800 watt power supplies for surges well inexcess of rated output power for SPL use- Three independent output filtering stages allow fullrange use as well as bass use in SQ systems- Optical isolation at each stage- ZAPCO DCS microprocessor control for all amplifierfunctions- Ultra high speed switching frequency for reduced"footprint" -Adjustable input gain up to 30.5 dB-Adjustable Pre-Clip circuitry enabling the user to set the maximum input  which in turn determines the desired output. power. Match RMS speaker power handling for best performance and reliability -Adjustable turn on delay from 1-4 seconds -XD-VFD in-dash display, with wired remote, allows monitoring and control of all functions from drivers position display shows, input voltage, amplifier rail voltage, temperature and output power- Variable, selectable 24dB or 48dB low passcrossover -Pass through output -Four layer PC board with heavy 3 oz copper -Surface Mount Technology w/1% resistors, precision capacitors, and massive ground planes -Switch for use as stereo , single L ch. or R ch. bridge -L+R sum mono for use as a bass amp- -Dual cooling fans allow any mounting position - Quality ZAPCO construction ** Designed and Manufactured in the USA ** Suggested Retail $ 3613.99 THIS AMP HAS ONLY BEEN USED FOR COMPETITION AND IS IN GREAT CONDITION. I HAVE THE BOOKLET AND THE BIRTH CERTIFICATE. **This item is also for sale off of ebay and auction will be cancelled if sold** Item was built without the Zapco emblem in the middle of the amp due to its use for competition.   Place a Bid!