ZAPCO C2K 9.0XD 2-CHANNEL FULL RANGE CAR AMPLIFIER Start Price USD 0.99 Current Price USD 1,525.00 Time Left - Bid Count 24 Buy It Now Price - Reserve Price - Start Time Wednesday, August 27, 2008 End Time Wednesday, September 03, 2008 Location Lehighton, Pennsylvania See more about 'ZAPCO C2K 9.0XD 2-CHANNEL FULL RANGE CAR AMPLIFIER' Description Up for auction: ZAPCO C2K 9.0XD 2-CHANNEL FULL RANGE CLASS D CAR AMPLIFIER Never installed, great condition open box amplifier.This is a very high level amplifier capable of producing over 2,000 watts of pure power RMS!Specs: 2-Channel High Efficient Full Range Class D Amplifier with Tripath Microprocessor Control Technology Over 2000 Watt RMS Power into 4 Ohm Configuration -Chassis design allows infinite customization options by replacing slide-in trim panels to personalize any installation- SymbiLink™ Balanced Line Technology provides up to 16 volts of balanced input for the cleanest, quietest signal possible -Dual 1,800 watt power supplies for surges well in excess of rated output power for SPL use- Three independent output filtering stages allow full range use as well as bass use in SQ systems- Optical isolation at each stage- ZAPCO DCS microprocessor control for all amplifier functions- Ultra high speed switching frequency for reduced "footprint" -Adjustable input gain up to 30.5 dB-Adjustable Pre-Clip circuitry enabling the user to set the maximum input  which in turn determines the desired output. power. Match RMS speaker power handling for best performance and reliability -Adjustable turn on delay from 1-4 seconds -XD-VFD in-dash display, with wired remote, allows monitoring and control of all functions from drivers position display shows, input voltage, amplifier rail voltage, temperature and output power- Variable, selectable 24dB or 48dB low pass crossover -Pass through output -Four layer PC board with heavy 3 oz copper -Surface Mount Technology w/1% resistors, precision capacitors, and massive ground planes -Switch for use as stereo , single L ch. or R ch. bridge -L+R sum mono for use as a bass amp- -Dual cooling fans allow any mounting position  Specifications: Stereo, 4 ohms: 2x300 Watts Stereo, 2 ohms: 2x600 Watts Stereo, 1 ohms: 2x600 Watts Bridged, 4 ohms: 1x2200 Watts Bridged, 2 ohms: 1x2200 Watts T.H.D. + Noise: <0.05% Frequency Response: 20Hz - 20kHz; +0 dB/-0.28 dB S/N Ratio: >85dB Transient Distortion: <0.009% Slew Rate: >20V/uS Damping Factor: >225 Input Sensitivity: 250mV -16 Volts Dimensions: 19.5"L x 8.75"W x 2.375"HOn Aug-27-08 at 13:00:10 PDT, seller added the following information:SquareTrade © AP6.0 SquareTrade © squaretrade warranty v2.0 Place a Bid!